NetComm Wireless 4GM3W User Guide
SNMP
SNMP (Simple Network Management Protocol) is a protocol designed to give a user the capability to remotely manage a
computer network by polling and setting terminal values and monitoring network events.
OPTION DEFINITION
Enable SNMP
You must check Local, Remote or both to enable SNMP function. If Local is checked, this device will only respond to requests
from LAN connected hosts. If Remote is checked, this device will respond to requests from the WAN connection.
Sets the community string your device will respond to for Read-Only access.
Sets the community string your device will respond to for Read/Write access.
IP 1, IP 2, IP 3, IP 4
Input your SNMP Management host IP here. You will need to configure the address where the device should send SNMP Trap
Please select proper SNMP Version that your SNMP Management software supports.
You can limit remote access to a specific IP address by entering it here.
Note: If "Remote" access is enabled, the default setting of 0.0.0.0 means any IP obtain SNMP protocol Information.
Click on Save to store your setting or Undo to discard your changes.
To Next Page
Loading...
Need help?
Operating Environment
Power
Ports & Interfaces
Weight and Dimensions
