Security Gateway Manual Netgate-8300
Note: These screws are captive and will not fully remove from the riser assembly. It is sufficient to loosen the
screws until they no longer attach the riser assembly to the motherboard. This may be felt as a soft “click” when
the screw is freely rotating and the threads are not engaged.
Fig. 50: Location of the captive riser assembly retaining screws indicated with red circles
2. Remove the riser assembly retaining screw on the front of the unit using the Phillips head screwdriver.
3. Carefully lift the riser assembly from the motherboard slot and remove the riser assembly.
Rotating the assembly as seen in figures below can help the removal process with PCIe cards installed.
© Copyright 2024 Rubicon Communications LLC 105
To Next Page
Loading...
