Security Gateway Manual Netgate-8300
Allow Other Traffic
Add rule to allow traffic from this interface network to any other destination, which enables clients on this interface to
reach the Internet and/or other remote public networks.
• Click to add a new rule at the bottom of the list.
• Configure the rule as follows:
Action
Pass
Interface
OPTx (or the custom name)
Protocol
Any
Source
OPTx subnets (or the custom name)
Destination
Any
Description
Default allow all from OPTx
• Click Save
Apply Changes
With the rules all in place, click Apply Changes to finish and activate the new rules.
The rules should look similar to the following figure:
Fig. 19: Example firewall rules for isolated LAN type segment
Tip: Rule separators are useful for documenting a ruleset in place.
© Copyright 2024 Rubicon Communications LLC 71
To Next Page
Loading...
