Security Gateway Manual Netgate-8300
Remove the M.2 NVMe Riser Card
The M.2 NVMe drives are located on a riser card near the PSU cages. This card must be removed to safely access the
SSDs.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
1. Locate the M.2 NVMe riser card
Fig. 29: M.2 NVMe riser card clips (circled) in the closed position
2. Lift both retaining clips holding the riser card in place to release the card
Fig. 30: M.2 NVMe riser card clips in the open position
3. Remove the riser card and set it aside
Install the SSD
With the riser card removed, it is time to install the SSD.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
1. Turn the riser card over so the second M.2 slot is visible.
© Copyright 2024 Rubicon Communications LLC 84
To Next Page
Loading...
