Security Gateway Manual Netgate-8300
5. Move the Netgate 8300 to a safe work location such as an anti-static mat
Removing the Lid
The next portion of the procedure involves opening the device and removing the lid.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
1. Remove the screws from the top of the case near the front of the unit using the Phillips head screwdriver.
Fig. 22: Screws on the top of the cover at the front of the unit, indicated with arrows
2. Remove the screw from the rear side of the unit at the top left corner using the Phillips head screwdriver.
3. Remove the screw from the rear side of the unit at the top right corner using the Phillips head screwdriver.
4. Slide the top cover back away from the front panel until it stops.
5. Lift off the top cover and set it aside, keeping it upright to avoid damaging the top surface.
Move the Fan Duct
The M.2 NVMe riser card is located under the fan duct. This duct can be moved out of the way sufficiently enough to
access the riser without completely removing it from the case.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
© Copyright 2024 Rubicon Communications LLC 77
To Next Page
Loading...
