Security Gateway Manual Netgate-8300
Fig. 58: Remove the expansion slot cover once it is free from the expansion slot
The rear of the socket has a retention clip to hold the card in place which should be engaged once the card is fully
seated
The front of the card should be flush with the front of the riser assembly and aligned with the retention screw
hole.
6. Fasten the expansion card to the riser assembly using the retaining screw and the Phillips head screwdriver.
Replace the Riser Assembly
With the expansion card installed in the riser assembly, replace the riser assembly back into the chassis.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
1. Insert the riser card back into the chassis and fully seat it into the slot on the motherboard.
2. Replace the riser assembly retaining screw on the front of the unit using the Phillips head screwdriver.
3. Tighten the two captive screws which attach the riser assembly to the motherboard using the Phillips head screw-
driver.
© Copyright 2024 Rubicon Communications LLC 111
To Next Page
Loading...
