Security Gateway Manual Netgate-8300
Replacing and Fastening the Lid
With the internal components all in place, the next step is to replace the lid and all its fasteners.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
1. Align the top cover with the top of the unit, a short distance behind the front panel.
Fig. 67: Top cover in position to be replaced
2. Slide the top cover toward the front of the unit into its closed position.
# Replace the screws on the rear of the unit (left and right top corners) using
the Phillips head screwdriver.
# Replace the screws on the top of the unit using the Phillips head screwdriver.
© Copyright 2024 Rubicon Communications LLC 119
To Next Page
Loading...
