Security Gateway Manual Netgate-8300
See also:
See Networking Ports for details.
If the device has an existing configuration which must be adjusted to match the new interface layout, then the ports must
be reassigned manually. Since GUI access is likely broken by the interfaces being moved, this may need to be performed
at the console. For simple configurations this may be viable, but for more complicated configurations involving LAGG,
VLANs, and so on it may be difficult.
Another option is to edit the configuration backup and adjust the interfaces manually, then perform a factory reset (Fac-
tory Reset Procedure) or reinstall pfSense Plus software (Reinstalling pfSense Plus Software) and restore the adjusted
configuration.
See also:
Netgate TAC may be able to assist with adjusting configurations for customers in many cases.
Re-arm the Intrusion Sensor
Opening the case to install the expansion card will trigger the intrusion alarm sensor, even while the device is removed
from power. The intrusion alarm causes the fans to run at a higher fixed speed until the sensor is re-armed.
Once pfSense software is up and running, follow the procedure in Re-arm the Chassis Intrusion Switch to reset the
sensor.
© Copyright 2024 Rubicon Communications LLC 125
To Next Page
Loading...
