Netgate 8300 - Page 47

Security Gateway Manual Netgate-8300
• List the current IPMI users
# ipmitool user list
Note: Netgate 8300 appliances use the user name root by default.
The command prints a list of users, for example:
ID Name Callin Link Auth IPMI Msg Channel Priv Limit
1 true false false NO ACCESS
2 root true false true ADMINISTRATOR
3 true false false NO ACCESS
4 true false false NO ACCESS
5 true false false NO ACCESS
6 true false false NO ACCESS
7 true false false NO ACCESS
8 true false false NO ACCESS
9 true false false NO ACCESS
10 true false false NO ACCESS
11 true false false NO ACCESS
12 true false false NO ACCESS
13 true false false NO ACCESS
14 true false false NO ACCESS
15 true false false NO ACCESS
Warning: Usernames are case-sensitive.
• Reset the password for a user
The default root user is User ID 2, and the example below sets the password for this user to NETGATE.
# ipmitool user set password 2 NETGATE
Warning: This password is for example purposes only. Use a secure password.
If successful, the output will be:
Set User Password command successful (user 2)
• Unload the IPMI kernel module
© Copyright 2024 Rubicon Communications LLC 45