Security Gateway Manual Netgate-8300
Replace the M.2 NVMe Riser Card and Fan Duct
With the new SSD installed, replace the riser card.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
1. Insert the riser card back into its slot on the motherboard
2. Close the retaining clips to secure the riser card.
3. Move the fan duct back to its original location.
4. Secure the fan duct with its screw using the Phillips head screwdriver.
Replacing and Fastening the Lid
With the internal components all in place, the next step is to replace the lid and all its fasteners.
Danger: Reminder:
• Anti-static protection must be used throughout this procedure.
• Any hardware damage incurred during this procedure is not covered by the hardware warranty.
1. Align the top cover with the top of the unit, a short distance behind the front panel.
2. Slide the top cover toward the front of the unit into its closed position.
# Replace the screws on the rear of the unit (left and right top corners) using
the Phillips head screwdriver.
# Replace the screws on the top of the unit using the Phillips head screwdriver.
Reconnect
The device is now ready to be put back into its former location.
1. Mount the Netgate 8300 in the rack
2. Plug in all network cables, USB cables and devices, serial console connections, etc.
3. Insert the USB memstick containing the installation media
4. Plug the power cables into all installed power supply units.
5. Turn power on to the unit by changing the power switch on the rear of the unit to the on position.
6. Reconnect to the serial console
© Copyright 2024 Rubicon Communications LLC 88
To Next Page
Loading...
