Connect and Get Started
27
AC1900, N900, and N450 WiFi Cable Data Gateways
Wi-Fi Protected Setup Method
Wi-Fi Protected Setup (WPS) is a standard for easily adding computers and other devices to
a home network while maintaining security. To use WPS (Push 'N' Connect), make sure that
all WiFi devices to be connected to the network are Wi-Fi certified and support WPS. During
the connection process, the client gets the security settings from the cable data gateway so
that every device in the network supports the same security settings.
To use WPS to connect a device to the WiFi network of the cable data gateway:
1. Press the WPS button on the front panel of the cable data gateway.
2. Within two minutes, press the WPS button on your WiFi device, or follow the WPS
instructions that came with the device.
The WPS process automatically sets up the device with the network password and
connects the device to the WiFi network of the cable data gateway.
For more information, see Use the WPS Wizard to Add a Device to the WiFi Network on
page 52.
To Next Page
Loading...
Need help?
General