NETGEAR CM1000v2 User Manual

The cable modem comes online when the Online LED stops blinking and lights solid
green.
This process might take up to 10 minutes.
5. Connect a computer to the cable modem.
Use the Ethernet cable that is provided in the package to connect a computer to the
Ethernet port on the cable modem.
6. Activate your Internet service.
For information about how to activate your Internet service, see Before you activate
your Internet service on page 11.
Note: After you install and activate the cable modem, you can disconnect the
computer and connect a router to the cable modem. For more information, see
Connect your cable modem to a router after installation and activation on page 14.
Before you activate your Internet service
Before you activate your Internet service, gather the following information:
•
Your cable Internet provider account information
•
Cable modem model number, which is CM1000v2
•
Cable modem serial number, which is on the cable modem label
•
Cable modem MAC address, which is on the cable modem label
Figure 6. Example of a cable modem label
The following is contact information for cable Internet providers that support your cable
modem.
User Manual11Hardware Setup
High Speed Cable Modem

NETGEAR CM1000v2 Specifications

Power

input voltage	110–120V, 47–60 Hz
output voltage	12 VDC
output current	1.5 A

Operating Environment

operating temperature	32° to 104°F (0° to 40°C)
operating humidity	90% maximum relative humidity, noncondensing

Interface

local ethernet port	One 10/100/1000 RJ-45 Gigabit Ethernet port
internet connector	Coaxial cable connector, DOCSIS 3.1; backward-compatible with DOCSIS 3.0
downstream channels	2 OFDM and 32 SC-QAM bonded

Weight and Dimensions

dimensions	8.8 in x 3.5 in x 5.9 in (223.5 mm x 88.9 mm x 150 mm)
weight	0.95 lb (431 g)