NETGEAR CM500 User Manual

Manage and Monitor
18
CM500 High Speed Cable Modem
5. Click the Reboot button.
A confirmation message displays.
6. Click the OK button.
The cable modem reboots.
Reset the Cable Modem to Factory Default Settings
To reset the cable modem to factory default settings, you can use either the Reset button on
the back panel of the cable modem or the Factory reset software button. However, if you
changed the default password to access the cable modem and lost the password, you must
use the Reset button on the back panel.
After you reset the cable modem to factory default settings, the user name is admin, the
password is password. The LAN IP address is always 192.168.100.1. Y
ou cannot change
this LAN IP address.
Use the Reset Button on the Back Panel
CAUTION:
This process erases all settings that you configured in the cable modem.
 To reset the cable modem to factory default settings:
1. Power on the cable modem.
2. On the back of the cable modem, locate the Reset button.
Reset button

NETGEAR CM500 Specifications

General

Supported network protocols	IPv6
Flash memory	8 MB
Internal memory	128 MB
DC-in jack	Yes
Ethernet LAN (RJ-45) ports	1
Cables included	LAN (RJ-45)

Weight and Dimensions

Depth	60 mm
Width	185 mm
Height	124 mm
Weight	280 g