Rear Panel
The connections and button on the rear panel are shown in the following figure.
Figure 1. Cable modem router rear panel
The back panel contains the following components:
1. USB port. Use the USB port to connect a USB storage device to the cable modem
router.
2. Ethernet ports 1 and 2. Two Gigabit Ethernet RJ-45 LAN ports to connect the cable
modem router to LAN devices.
3. Reset button. Pressing the Reset button resets the cable modem router. If the Reset
button is pressed for at least seven seconds and the Power LED blinks green, the
cable modem router returns to its factory settings.
User Manual11Hardware Setup
C6230 WiFi Cable Modem Router
To Next Page
Loading...
