NETGEAR EAX12 User Manual

5. Select Do More > FastLane.
The FastLane Technology page displays.
6. Select the FastLane Technology radio button.
The page adjusts and displays two more radio buttons.
7. Select a radio button:
• Router-to-Extender in 2.4 GHz only and Extender-to-Device in 5 GHz only.
The 5 GHz band is used to connect the extender to the WiFi devices, and the 2.4
GHz band is used to connect the extender to the WiFi router. Use this mode if the
devices that you want to use for gaming and streaming support the 5 GHz band,
but your WiFi router supports the 2.4 GHz band.
• Router to Extender in 5 GHz only and Extender-to-Device in 2.4 GHz only.
The 2.4 GHz band is used to connect the extender to the WiFi devices, and the 5
GHz band is used to connect the extender to the WiFi router. Use this mode if
your WiFi router supports the 5 GHz band, but the devices that you want to use
for gaming and streaming support the 2.4 GHz band.
8. Click the SAVE button.
Your changes are saved.
Configure a router with advanced MAC
settings to work with your extender
If you enabled a WiFi MAC filter, WiFi access control, or access control list (ACL) on your
router, when a WiFi device connects through the extender to your router, the MAC
address of the WiFi device shown on the router is translated to another MAC address.
If your router’s MAC filter, WiFi access control, or ACL is enabled, the WiFi device
connects to the extender but cannot get an IP address from the extender and cannot
access the Internet.
To allow the WiFi device to receive an IP address from the extender and access the
Internet, you must provide translated MAC address to the router.
To add a translated MAC address to your router and reserve an IP address for your
extender
1.
Log in to your router and disable the MAC filter, WiFi access control, or ACL.
For more information about how to disable your router’s MAC filter, WiFi access
control, or ACL, see your router’s documentation.
2.
Power on the extender and connect all of your WiFi devices to the extender.
User Manual45Extender Network Settings
AX1600 4-Stream WiFi 6 Mesh Extender

NETGEAR EAX12 Specifications

General

2.4 GHz	Yes
Frequency band	2.4 - 5 GHz
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	1200 Mbit/s
Maximum data transfer rate (2.4 GHz)	400 Mbit/s
Security algorithms	128-bit AES, WPA3-PSK
USB 2.0 ports quantity	0
Ethernet LAN (RJ-45) ports	1
Power over Ethernet (PoE)	No
Placement	Wall
Product color	White
Housing material	Plastic
Antenna type	Internal
Antennas quantity	2
Number of products included	1 pc(s)
Package type	Box
Processor frequency	880 MHz
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	52.3 mm
Width	68.4 mm
Height	149 mm
Weight	490 g