NETGEAR GS408EPP Hardware Installation Guide

Features
The switch supports the following key hardware features:
•
8 Gigabit Ethernet ports that support PoE+ (802.3at).
•
Total PoE power budget of 124W for the switch.
•
16 Gbps switching fabric (duplex mode, all ports line-rate).
•
Industry-unique chassis for desktop operation, wall operation, rack-mounting in a
wiring closet or equipment room, or attachable almost anywhere using the
Easy-Mount system.
•
Full compatibility with IEEE standards:
- IEEE 802.3 Ethernet
- IEEE 802.3u 100BASE-T
- IEEE 802.3z Gigabit Ethernet 1000BASE-SX/LX
- IEEE 802.3ab 1000BASE-T
- IEEE 802.3i 10BASE-T
- IEEE 802.1Q VLAN tagging
-
IEEE 802.3x Full-duplex flow control
-
IEEE 802.1p Class of Service (QoS)
-
IEEE 802.3az Energy Efficient Ethernet (EEE)
-
IEEE 802.1af (PoE)
- IEEE 802.1at (PoE+)
•
AutoSensing and autonegotiating capabilities for all ports.
•
Auto Uplink technology is supported on all ports.
•
Automatic address learning function to build the packet-forwarding information
table. The table contains up to 8K Media Access Control (MAC) addresses.
•
Store-and-forward transmission to remove bad packets from the network.
•
Active flow control to minimize packet loss and frame drops.
•
Half-duplex backpressure control.
•
Per-port status LEDs and system status LEDs.
•
Per-port PoE status LEDs and system PoE Max LED.
Hardware Installation Guide6Introduction
8-Port Easy Mount Gigabit Ethernet PoE+ Smart Managed Plus Switch GS408EPP

NETGEAR GS408EPP Specifications

General

Brand	NETGEAR
Model	GS408EPP
Category	Switch
Language	English