NETGEAR GS716T - Chapter 1 Switch Information and Setup

5
GS716T, GS724T and GS748T Gigabit Smart Switch
Features
• GS716Tv3/GS724Tv4 has 16/24 10/100/1000Mbps ethernet copper ports and 2
dedicated 1000Mbps fiber ports.
• GS748Tv5 has 48 10/100/1000Mbps ethernet copper port, 2 Combo ports and 2
dedicated 1000Mbps fiber ports.
• The following SFP types are supported:
• 1000BASE-SX
• 1000BASE-LX
• 100BASE-FX (for combo ports on GS748T only)
• The devices support full NETGEAR Smart Switch functionality.
• The devices provide full compatibility with IEEE standards:
• IEEE 802.3i, (10BASE-T)
• IEEE 802.3u (100BASE-TX, 100BASE-FX)
• IEEE 802.3x (Full-duplex flow control)
• IEEE 802.3ab (1000BASE-T)
• IEEE 802.3z (1000BASE-X)
• Auto-sensing and auto-negotiating capabilities for all ports.
• Auto Uplink™ on all ports to make the right connection.
• Automatic address learning function to build the packet-forwarding information table. The
table contains up to 16K Media Access Control (MAC) addresses.
• Full-duplex and half-duplex functions for all 10/100/1000 Mbps ports.
• Store-and-Forward transmission to remove bad packets from the network.
• Full-duplex IEEE 802.3x pause frame flow control.
• Active flow control to minimize packet loss/frame drops.
• Half-duplex back-pressure control.
• Per port LEDs, System LEDs.
• Standard NETGEAR 7xx series chassis.
• NETGEAR Green product series power-saving features:
• Automatic power consumption adjustment based on the RJ-45 cable length.
• Per port automatic power down when the port link is down.
• Energy Efficient Ethernet (EEE), defined by IEEE 802.3az, supports operation in a Low
Power Mode.