Why is file transfer slow on my NETGEAR GS724TPv2?
Slow file transfers on your NETGEAR Switch can occur due to a broadcast storm caused by a network loop (redundant path). To resolve this, ensure only one path exists between any two networked devices to break the loop. You can also configure the Spanning Tree Protocol (STP) via the switch's web management interface to prevent network loops.
What to do if combined speed and activity LED are blinking continuously on all connected ports and the network is disabled on NETGEAR Switch?
Continuously blinking LEDs on all ports of your NETGEAR Switch, accompanied by network disability, indicates a network loop (redundant path). To fix this, ensure only one path exists between any two networked devices to break the loop. You can also configure the Spanning Tree Protocol (STP) via the switch's web management interface to prevent network loops.
What to do if a segment or device is not recognized as part of the network by NETGEAR GS724TPv2 Switch?
If a segment or device isn't recognized on your NETGEAR Switch network, it could be due to improper connections or cabling that doesn't meet Ethernet guidelines. Verify that the cabling is correct and that all connectors are securely positioned in the required ports. Ensure that no equipment has been accidentally disconnected.
What to do if combined speed and activity LED is off when the port is connected to a device on NETGEAR Switch?
If the speed and activity LED is off when a port is connected to a device on your NETGEAR Switch, the port connection may not be working. Check the crimp on the connectors, ensure the plug is properly inserted and locked into the port at both ends. Also, make sure all cables are used correctly and comply with Ethernet specifications. Test for defective port, cable, or module by testing them in an alternate environment where all products are functioning.
To Next Page
General