Advanced Settings
66
N150 4-Port Wireless Router JNR1010
Wireless Repeating Function
Select Advanced > Advanced Setup > Wireless Repeating to view or change wireless
repeater settings for the router.
You can configure the following wireless repeater settings:
• Enable W
ireless Repeating Function. Select the check box for the 2.4 GHz or 5 GHz
network to use the wireless repeating function.
• W
ireless MAC of this router. This field displays the MAC address for your router for your
reference. You will need to enter this MAC address in the corresponding Wireless
Repeating Function screen of the other access point you are using.
• W
ireless Repeater. If your router is the repeater, select this check box.
• Repeater IP
Address. If your router is the repeater, enter the IP address of the other
access point.
• Disable W
ireless Client Association. If your router is the repeater, selecting this check
box means that wireless clients cannot associate with it. Only LAN client associations are
allowed.
• If you are setting up a point-to-point bridge, select the Disable Wireless Client
Association check box.
• If you want all client traf
fic to go through the other access point (repeater with wireless
client association), leave the Disable Wireless Client Association check box cleared.
• Base Station MAC
Address. If your router is the repeater, enter the MAC address for the
access point that is the base station.
• W
ireless Base Station. If your router is the base station, select this check box.
To Next Page
Loading...
Need help?
General
