genie Basic Settings
26
N150 4-Port Wireless Router JNR1010
To view or change basic wireless settings:
1. On the Basic Home screen, select Wireless to display the Wireless Settings screen.
The screen sections, settings, and procedures are explained in the following sections.
2. Make any changes that are needed and click Apply to save your settings.
3. Set up and test your wireless devices and computers to make sure that they can connect
wirelessly
.
If they do not, check the following:
• Is your wireless device or computer connected to your network or another wireless
network in your area? Some wireless devices automatically connect to the first open
network (without wireless security) that they discover
.
• Does your wireless device or computer show up on the
Attached Devices screen? If it
does, then it is connected to the network.
• If you are not sure what the network name (SSID) or password is, look on the label on
the bottom of your router.
Wireless Settings Screen Fields
You can configure the following wireless settings:
• Region.
The location where the router is used. Select from the countries in the list. In the
United States, the region is fixed to United States and is not changeable.
• Enable W
ireless Isolation. If this check box is selected, then computers or wireless
devices that join the network can use the Internet, but cannot access each other or
access Ethernet devices on the network.
• Enable SSID Broadcast. This setting allows the router to broadcast its SSID so wireless
stations can see this wireless name (SSID) in their scanned network lists.
This check box
is selected by default. To turn off the SSID broadcast, clear the Allow Broadcast of Name
(SSID) check box and click Apply.
To Next Page
Loading...
Need help?
General
