NETGEAR JWNR2010v5 N300 - Basic Wireless Settings

genie BASIC Settings
28
JWNR2010v5 N300 Wireless Router
Your Internet connection is tested. If the router does not detect the Internet connection
and the NETGEAR website does not display within one minute, see
Chapter 8,
Troubleshooting.
Basic Wireless Settings
You can view or configure the wireless network setup.
The router comes with preset WPA2-PSK security. This means that the WiFi network name
(SSID), wireless network password (also referred to as the passphrase or network key), and
security option (authentication and encryption protocol) are preset in the factory. You can find
the preset SSID and password on the router label. The preset SSID and password are
uniquely generated for every device to protect and maximize your wireless security.
WARNING:
NETGEAR recommends that you do not change your preset
security settings. If you do decide to change your preset security
settings, make a note of the new settings and store it in a safe place
where you can easily find it.
Note: If you use a wireless computer to change the wireless network name
(SSID) or other wireless security settings, you are disconnected when
you click the Apply button. To avoid this situation, use a computer
with a wired connection to access the router.
 To view or change basic wireless settings:
1. Log in to the router.
For more information, see Log In to Your Router After Installation on page 18.
2. Select BASIC > Wireless.