genie ADVANCED Home
46
JWNR2010v5 N300 Wireless Router
LAN Setup
You can configure LAN IP services such as Dynamic Host Configuration Protocol (DHCP)
and Routing Information Protocol (RIP).
The router is shipped preconfigured to use private IP addresses on the LAN side and to
function as a DHCP server. The router’s default LAN IP configuration includes the following
settings:
• LAN IP address. 192.168.1.1
• Subnet mask. 255.255.255.0
These addresses are part of the designated private address range for use in private networks
and are suitable for most applications. If your network requires the use of a different IP
addressing scheme, change the settings in the LAN Setup screen.
Note: If you change the LAN IP address of the router while connected
through the browser, you are disconnected. If this situation occurs,
you must open a new connection to the new IP address and log in
again.
To change the LAN settings:
1. Log in to the router.
For more information, see Log In to Your Router After Installation on page 18.
2. Select ADVANCED > Setup > LAN Setup.
To Next Page
Loading...
