Supplemental Information
88
JWNR2010v5 N300 Wireless Router
Factory Settings
You can return the router to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the WPS/Rest button on the back panel of the router for at
least four seconds. The router resets, and returns to the factory settings that are shown in the
following table.
Table 4. JWNR2010v5 router factory default settings
Feature Default Behavior
Router login User login URL www.routerlogin.com or www.routerlogin.net
User name (case-sensitive) admin
Login password (case-sensitive) password
Internet
connection
WAN MAC address Use default hardware address
WAN MTU size 1500
Port speed AutoSensing
Local area
network (LAN)
LAN IP 192.168.1.1
Subnet mask 255.255.255.0
DHCP server Enabled
DHCP range 192.168.1.2 to 192.168.1.254
Time zone United States is Pacific Time; otherwise, varies by region
Time zone adjusted for daylight
saving time
Disabled
Wireless Wireless communication Enabled
SSID name
Preset. For information, see the router label. (For a
description of the router label, see Label on page 11.)
Network key (password)
Broadcast SSID Enabled
Transmission speed Auto
Note: Maximum wireless signal rate derived from IEEE
Standard 802.11 specifications. Actual throughput varies.
Network conditions and environmental factors, including
volume of network traffic, building materials and
construction, and network overhead lower actual data
throughput rate.
Country/region United States in the US; otherwise, varies by region
RF channel Auto
Operating mode Up to 300 Mbps
To Next Page
Loading...
