NETGEAR M4250 Series

To Next Page

To Previous Page

• Switches are certified by the Avnu Alliance for AVB support.

• Dedicated AV web-based GUI interface that allows the application of port-based profiles for different AV

protocols to simplify switch configuration for different supported AV protocols.

• Dedicated console (serial and USB) and out-of-band network ports for configuration and management

• Support for up to 256 AVB streams

• Out-of-box switches will be running a default Biamp config file that includes all the AVB profile settings for proper

operation using default VLAN 2 for AVB traffic.

• Spanning tree limits daisy chain/buss topologies to 7 switch hops. Biamp recommends max 6 switches in a plug-

and-play system not requiring additional configuration.

• Designs incorporating different switch models, or mixed networks, or VLANs will require design assistance from

Netgear.

• (24) 1G PoE+ ports, 240W total budget

• (2) standard 1G LAN ports

• (4) SFP + ports to support switch topology expansion.

• Fiber media converters are not supported for QT X controllers connected to SFP ports while running in AVB

configurations.

Notes:

• AVB license will be installed and activated on each switch when shipped.

• Netgear switches will be updated to the latest public firmware release.

• AVB is not supported over LAG.

Auto-trunk

Auto-Trunk provides an effortless ability to configure multiple VLANs onto an uplink Ethernet port or any unused

Ethernet port. By simply setting up the pre-configured network profile or VLANs on a specified port, the M4250

automatically configures the enabled, unused Ethernet port (preferably used for interconnect) to support all the VLANs

configured on the switch.

Other manuals for NETGEAR M4250 Series