VPN passthrough is enabled by default.
3. Click or tap Apply.
Your settings are saved.
Disable or re-enable UPnP from the
web user interface
Universal Plug and Play (UPnP) helps devices and computers access the network and
connect to other devices as needed. UPnP devices can automatically discover the
services from other registered UPnP devices on the network.
If you use applications such as multiplayer gaming, peer-to-peer connections, or real-time
communications such as instant messaging, keep UPnP enabled, which is its default
setting.
When UPnP is disabled, the router does not allow any device to automatically control
router resources, such as port forwarding.
To disable or re-enable UPnP from the web user interface:
1. From the web user interface dashboard, select Settings > Advanced > Other.
The Other page displays.
2. In the UPnP section, clear the Enable check box to disable UPnP, or select the check
box to re-enable it.
UPnP is enabled by default.
3. (Optional) If you enabled UPnP, select a UPnP IGD Version from the menu.
This setting typically does not need to be changed unless a specific application or
device requires it.
4. Click or tap Apply.
Your settings are saved.
Configure a DMZ server from the
web user interface
In a demilitarized zone (DMZ) network configuration, a computer runs outside the firewall
in the DMZ. This computer intercepts incoming Internet traffic, providing an extra layer
User Manual70Access the web user interface
Nighthawk M7 Ultra
To Next Page