Router Setup
29
N150 WiFi Router (N150R)
LAN Ports
The LAN Ports screen allows configuration of LAN IP services such as Dynamic Host
Configuration Protocol (DHCP) and Routing Information Protocol (RIP).
The router is shipped preconfigured to use private I
P addresses on the LAN side and to act
as a DHCP server. The router’s default LAN IP configuration is:
• LAN IP add
ress. 192.168.1.1
• Subne
t mask. 255.255.255.0
These addresses are part of the designated private address range for use in private
networks a
nd are suitable for most applications. If your network requires a different IP
addressing scheme, you can change these settings in the LAN Setup screen.
To change the LAN settings:
Note: If you change the LAN IP address of the router while connected
through the browser, you will be disconnected. You will have to open
a new connection to the new IP address and log in again.
1. Select Setup > LAN Ports to display the following screen:
2. Enter the settings that you want to customize. These settings are described in the following
section, LAN TCP/IP Setup.
3. Click Apply to save your chang
es.
LAN TCP/IP Setup
• IP Address. The LAN IP address of the router.
To Next Page
Loading...
Need help?
General
