Advanced Settings
67
N150 WiFi Router (N150R)
2. Select Advanced > WiFi Repeating to display the Wireless Repeating Function screen.
3. In the Wireless Repeating Function screen, select the Enable Wireless Repeating
Function check box and select the Wireless Base Station radio button.
4. Enter the
MAC address for one or more repeater units.
5. Click Apply to save your chang
es.
Set Up a Repeater Unit
Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the
wireless connection to the base station.
Note: If you are using the N150R base station with a different router as the
repeater, you might need to change additional configuration
settings. In particular, you should disable the DHCP server function
on the wireless repeater AP.
To configure the router as a repeater unit:
1. Log
in to the router that will be the repeater. Select Setup > WiFi Settings and verify
that the wireless settings match the base unit exactly. The wireless security option has
to be set to WEP or None.
2. Select Ad
vanced > WiFi Repeating Function, and select the Enable Wireless Repeating
Function check box and the Wireless Repeater radio button.
3. Fill in the Re
peater IP Address field. This IP address has to be in the same subnet as the
base station, but different from the LAN IP address of the base station.
4. Click Apply to save your chang
es.
5. V
erify connectivity across the LANs.
A computer on any wireless or wired LAN segment of the router should be able to
co
nnect to the Internet or share files and printers with any other wireless or wired
computer or server connected to the other access point.
To Next Page
Loading...
Need help?
General
