Advanced Settings
64
N150 WiFi Router (N150R)
Tip: You can copy and paste the MAC addresses from the Attached Devices
screen into the MAC Address field of this screen. To do this, configure
each wireless computer to obtain a wireless link to the router. The
computer should then appear in the Attached Devices screen.
4. Click Add t
o add this wireless device to the Wireless Card Access List. The screen changes
back to the list screen.
5. Add
each computer or device you want to allow to connect wirelessly.
6. Sele
ct the Turn Access Control On check box.
7. Click Ap
ply.
WiFi Repeating (WDS)
You can set the N150R router up to be used as a wireless access point (AP). Doing this
enables the router to act as a wireless repeater. A wireless repeater connects to another
wireless router as a client where the network to which it connects becomes the ISP service.
Wireless repeating is a type of Wireless Dist
ribution System (WDS). A WDS allows a
wireless network to be expanded through multiple access points instead of using a wired
backbone to link them. The following figure shows a wireless repeating scenario.
Repeater
Base station
access point
access point
Figure 7. Wireless repeating scenario
To Next Page
Loading...
Need help?
General
