genie BASIC Settings
33
N450 Wireless Router WNR2500
WEP
Wired Equivalent Privacy (WEP) security is an authentication and data encryption mode that
is superseded by WPA-PSK and WPA2-PSK. WEP supports speeds of up to 54 Mbps and
does not function with WPS. However, if you set up a wireless distribution system (see
Wireless Distribution System on page 82), WEP is the only security that can be supported.
Note: The WEP option displays only if you select Up to 54 Mbps from the
Mode list.
To configure WEP security:
1. Select BASIC > Wireless
.
2. In the Security Options sections of the Wireless Settings screen, select the WEP radio
button.
3. In the Authentication Type list, select one of the following types:
• Automatic. If you enter a passphrase in the Passphrase field and click the Generate
button, the four keys are automatically generated.
• Shared Key. If you select this option, you must select one key and enter the value
manually.
4. In the Encryption Strength list, select the encryption key size:
• 64-bit
. Standard WEP encryption, using 40/64-bit encryption.
• 128-bit. Standard WEP encryption, using 104/128-bit encryption. This selection
provides higher encryption security
.
5. Depending on the authentication type, generate the key automatically or enter it manually:
• If the authentication type is Automatic:
a. In the Passphrase field, enter a passphrase:
To Next Page
Loading...
