NETGEAR N450 WNR2500 - Bandwidth Control

genie ADVANCED Home
61
N450 Wireless Router WNR2500
• To remove the device from the table, click the Delete button.
• To edit the MAC address, device name, or priority, click the Edit
button.
Edit the information you want to change.
Note: You cannot delete or edit a device that is detected and automatically
added to the MAC Device List.
6. Click the Apply button.
The device information is saved or removed from the MAC Device List.
Bandwidth Control
Bandwidth control lets you set a limit to the bandwidth that is available for traffic from the
router to the Internet.
 To set the maximum uplink bandwidth:
1. Select ADVANCED > Setup > QoS Setup
.
A screen similar to the following displays:
2. Select the Turn Bandwidth Control On check box.
3. Select the Automatically check Internet Uplink bandwidth radio button.
4. Click the Check button.
The router detects the available uplink bandwidth. After about one minute, the available
bandwidth displays onscreen.
This information can help you to determine the maximum
bandwidth setting that you want to allow
.
5. Select the Uplink bandwidth radio button.
6. Enter the maximum bandwidth that you want to allow, and select either Kbps
or Mbps.