Advanced Settings
84
N450 Wireless Router WNR2500
• The security option must be WEP (or no security). The WEP option displays only if you
select Up to 54 Mbps from the Mode list on the Wireless Settings screen (see Basic
Wireless Settings on page 28).
Set Up the Base Station
The wireless repeating function works only in hub and spoke mode. The units cannot be
daisy-chained. You must know the wireless MAC addresses of all units. First, set up the base
station and then set up the repeater.
To set up the base station:
1. Select ADVANCED >
Advanced Setup > Wireless Repeating Function.
The Wireless Repeating Function screen displays. The wireless MAC address of the
router displays onscreen.
2. Select the Enable Wireless Repeating Function
check box.
3. Select the Wireless Base Station radio button.
4. To prevent wireless clients from associating with the base station and allow LAN client
associations only, select the Disable Wireless Client Association check box.
You can leave the check box cleared if you prefer wireless clients to be able to associate
with the base stations.
5. In the Repeater MAC Address 1 through 4 fields, enter the MAC addresses for the access
points that should function as repeaters.
To Next Page
Loading...
