NETGEAR Nighthawk C7000 - Erase the Current Configuration Settings; View Wireless Access Points in Your Area

Manage Your Network
87
Nighthawk AC1900 WiFi Cable Modem Router
Erase the Current Configuration Settings
You can erase the current configuration and restore the factory default settings. You might
want to do this if you move the modem router to a different network. (See
Factory Settings on
page 119).
 To erase the configuration settings:
1. Launch an Internet browser from a computer or wireless device that is connected to the
network.
2. Type http://www.routerlogin.net or http://www.routerlogin.com.
A login screen displays.
3. Enter the user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.
4. Select ADVANCED > Administration > Backup Settings.
5. Click the Erase button.
The factory default settings are restored. The user name is admin, the password is
password, and the LAN IP address is 192.168.0.1. DHCP is enabled.
View Wireless Access Points in Your Area
You can view wireless networks or access points, in your area and select and join a wireless
network.
 To manage your wireless access point (AP):
1. Launch a web browser from a computer or wireless device that is connected to the
network.
2. Type http://routerlogin.net or http://192.168.0.1.
A login screen displays.
3. Enter the modem router user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.