NETGEAR Nighthawk C7000 - Add a Port Triggering Service

Specify Internet Port Settings
99
Nighthawk AC1900 WiFi Cable Modem Router
Add a Port Triggering Service
 To add a port triggering service:
1. Launch an Internet browser from a computer or wireless device that is connected to the
network.
2. T
ype http://www.routerlogin.net or http://www.routerlogin.com.
A login screen displays.
3. Enter the user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.
4. Select ADV
ANCED > Advanced Setup > Port Forwarding/Port Triggering.
5. Select the Port T
riggering radio button.
6. Click the Add Service button.
7. In the Service Name field, type a descriptive service name.
8. In the Service User list, select Any
, or select Single address and enter the IP address of
one computer:
• Any (the default) allows any computer on the Internet to use this service.
• Single address restricts the service to a particular computer
.
9. Select the service type, either TCP or UDP or TCP/UDP (both).
If you are not sure, select TCP/UDP.
10. In the T
riggering Port field, enter the number of the outbound traffic port that will open the
inbound ports.
11. Enter the inbound connection port information in the Connection T
ype, Starting Port, and
Ending Port fields.
12. Click the Apply button.