The page adjusts to display the WEP radio button.
6. Click the Apply button.
Your settings are saved.
7.
Do one of the following:
•
Set up WEP security for your WiFi network. Continue with Step 8.
•
Set up WEP security for the guest WiFi network. Do the following:
a. Select Guest Network.
The Guest Network Settings page displays.
b. Continue with Step 8.
8. In the Security Options section, select the WEP radio button.
The page adjusts.
9.
From the Authentication Type menu, select one of the following types:
• Automatic. Clients can use either Open System or Shared Key authentication.
• Shared Key. Clients can use only Shared Key authentication.
10. From the Encryption Strength menu, select the encryption key size:
• 64-bit. Standard WEP encryption, using 40/64-bit encryption.
• 128-bit. Standard WEP encryption, using 104/128-bit encryption. This selection
provides higher encryption security.
11.
Specify the active key by selecting the Key 1, Key 2, Key 3, or Key 4 radio button.
Only one key can be the active key. To join the router’s WiFi network, a user must
enter the key value for the key that you specified as the active key.
12.
Enter a value for the key:
•
For 64-bit WEP, enter 10 hexadecimal digits (any combination of 0–9, A–F). The
key values are not case-sensitive.
•
For 128-bit WEP, enter 26 hexadecimal digits (any combination of 0–9, A–F). The
key values are not case-sensitive.
13. Click the Apply button.
Your settings are saved.
14. Make sure that you can reconnect over WiFi to the network with its new settings.
User Manual93Manage the WiFi Network
Settings
Nighthawk AC2300 Cybersecurity WiFi Router Model RS400
To Next Page
Loading...
Need help?
General
Weight and Dimensions
