prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
6.
If already you set up your IPv4 ISP connection for PPPoE and want to use the same
login information for IPv6, select the Use the same Login information as IPv4
PPPoE check box.
To manually configure the PPPoE settings for IPv6, specify the following settings:
•
Login: Enter the login name that your ISP gave you. This is usually the name that
you use in your email address. For example, if your main mail account is
JerAB@ISP.com, you would type JerAB in this field. Some ISPs (like Earthlink)
require that you use your full email address when you log in. If your ISP requires
your full email address, type it in this field.
•
Password. Enter the password for the ISP connection.
•
Service Name (if Required). Enter a service name. If your ISP did not provide a
service name, leave this field blank.
Note: The default setting of the Connection Mode field is Always On to provide a
steady IPv6 connection. The router never terminates the connection. If the connection
is terminated, for example, when the modem is turned off, the router attempts to
reestablish the connection immediately after the PPPoE connection becomes available
again.
7. In the IPv6 Domain Name Server (DNS Address), select a radio button
•
Get Automatically from ISP: Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns this address.
•
Use These DNS Servers: If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP’s primary DNS server. If a secondary
DNS server address is available, enter it also.
8. In the LAN Setup section, select an IP Address Assignment radio button:
•
Use DHCP Server: This method passes more information to LAN devices, but
some IPv6 systems might not support the DHCPv6 client function.
•
Auto Config: This is the default setting.
This setting specifies how the router assigns IPv6 addresses to the devices on your
business network (the LAN).
9.
(Optional) Select the Use This Interface ID check box and specify the interface ID
that you want to be used for the IPv6 address of the router’s LAN interface.
User Manual53Specify Your Internet Settings
Orbi Pro WiFi 6 AX6000 Router Model SXR80 and Orbi Pro WiFi 6 AX6000 Satellite Model SXS80
To Next Page
Loading...
Need help?
General
