NETGEAR ProSafe GS108 Install Guide

)NSTALLATION'UIDE
GS108T 8-Port Smart Switch
Start Here
Follow these instructions to set up your smart switch.
Prepare to Install Your Smart Switch
• Prepare a PC with an Ethernet adapter and a CD ROM drive.
• Before proceeding with the smart switch installation, familiarize yourself with
the contents of the Resource CD, especially the manuals.
First, Install the SmartWizard Discovery Utility on a PC
1. Power on your PC, let the operating system boot up, and log in as needed.
2. Insert the Resource CD for the Smart Switch Series into your CD-ROM drive.
The CD main page shown below will load.
3. Click Install. Follow the prompts to complete the installation of the
SmartWizard Discovery utility.
4. Click OK when done.
Next, Connect Your Smart Switch in the Correct
Order
Note: These instructions assume you are using DHCP in your network. If you are
using static IP addressing in your network, configure the switch IP address before
connecting it to your network. In the absence of a DHCP server, the switch will
default to 192.168.0.239 for its IP address. To configure the switch before
connecting it to your network, set up the PC with an IP address in the 192.168.0.x
subnet, and connect the PC to the switch. Then, use the SmartWizard Discovery
utility as illustrated below to configure the switch.
1. Connect the smart switch to your network.
2. Connect the external power supply and power on the switch.
3. Verify that the PC with the SmartWizard Discovery utility is on the same
subnet as the switch.
Servers Computers Printers
Smart Switch
Now, Configure the Switch with the SmartWizard
Discovery Utility
1. Double click the SmartWizard Discovery icon on your desktop or in
Windows Start menu Programs to run the utility and view this screen.
2. Click Discover to find your switch in the network.
PC with SmartWizard Discovery Utility
Smart Switch

NETGEAR ProSafe GS108 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	1 Gbit/s
Full duplex	Yes
Networking standards	IEEE 802.3ab, IEEE 802.3i, IEEE 802.3u
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Latency	20 μs
Dimensions (WxDxH)	235.5 x 100.8 x 27 mm
Power requirements	5 V @ 2.8 A DC
Networking features	Ethernet, Fast Ethernet, Gigabit Ethernet
Switch type	Unmanaged
Basic switching RJ-45 Ethernet ports quantity	8
Noise level	0 dB
Mean time between failures (MTBF)	91.500 h
Power consumption (typical)	14 W
Safety	UL (UL 1950), CUL, C-Tick
LED indicators	Link, Power
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	760 g