NETGEAR RangeMax WNDA3100 User Manual

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
1-6
v1.0, December 2007
3. For Windows Vista computers, the adapter and driver are automatically added. Click Next and
then go to the following section “Using the Smart Wizard to Set Up Your Wireless-N USB
Adapter” on page 1-6. For Windows XP computers, the Found New Hardware Wizard
displays.
4. Follow the onscreen instructions for the Found New Hardware Wizard.
5. When the NETGEAR Smart Wizard screen returns, click Next.
Using the Smart Wizard to Set Up Your Wireless-N USB Adapter
After you have connected the wireless USB adapter, the following screen displays:
Windows XP or Vista users can set up the wireless adapter either with the NETGEAR Smart
Wizard (recommended) or the Windows configuration utilities.
• NETGEAR Smart Wizard. Reveals more information about each network and makes it
easier to troubleshoot network connection problems.
• Windows configuration utilities. See the Windows documentation or the NETGEAR
application note at: http://documentation.netgear.com/reference/enu/winzerocfg/index.htm.
To set up your wireless USB adapter with the NETGEAR Smart Wizard:
1. Click Next to proceed.
Figure 1-3

NETGEAR RangeMax WNDA3100 Specifications

General

Category	Wireless Adapter
Interface	USB 2.0
Wireless Standards	IEEE 802.11a/b/g/n
Frequency Band	2.4 GHz / 5 GHz
Wireless Data Rates	Up to 300 Mbps
Security	WEP, WPA-PSK, WPA2-PSK
Operating Systems Supported	Windows XP, Windows Vista