NETGEAR RangeMax WNDA3100 User Manual

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
2-17
v1.0, December 2007
Advanced Settings
You can use the Advanced Settings screen to configure the preamble (GHz) that the adapter uses.
The available settings are Auto, 2.4 GHz, and 5 GHz. You can use the 5GHz range to avoid
interference in the 2.4GHz range. The 2.4GHz range is commonly used by cordless telephones.
By changing the preamble setting, you have the option to connect to the following types of
wireless networks.
• 2.4 GHz + 5GHz. Connect to both 2.4GHz and 5GHz access points, up to 300 Mpbs.
• 2.4 GHz only. Connect only to 2.4GHz access points, up to 300 Mpbs.
• 5 GHz only. Connect only to 5 GHz access points, up
to 300 Mpbs.
• 2.4 GHz. Connect to 802.11b/g access points, up to 54 Mbps.
• 5 GHz. Connect to 802.11a access points, up to 54 Mbps.
To change the preamble (GHz) setting:
1. On the Settings tab, click the Advanced Settings button to display the following screen.:
Note: The default settings for the Fragmentation Threshold field and RTS/CTS
Threshold field usually work fine. Do not change them unless you have a specific
reason to do so.
Figure 2-13
Note: for Windows Vista computers, you must have administrator rights. Otherwise,
this option is not available for selection.

NETGEAR RangeMax WNDA3100 Specifications

General

Category	Wireless Adapter
Interface	USB 2.0
Wireless Standards	IEEE 802.11a/b/g/n
Frequency Band	2.4 GHz / 5 GHz
Wireless Data Rates	Up to 300 Mbps
Security	WEP, WPA-PSK, WPA2-PSK
Operating Systems Supported	Windows XP, Windows Vista