NETGEAR RangeMax WNDA3100 User Manual

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
2-13
v1.0, December 2007
Setting Up WEP Encryption Security
Follow the steps below to configure WEP encryption security:
1. Run the WNDA3100 Smart Wizard.
a. Make sure that the WNDA3100 software is installed and the wireless USB adapter is
connected to the USB port in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab displays:
2. Configure the Security settings.
a. In the Profile field, select the profile or type in a profile name.
b. In the Network Name (SSID) field, select the network, or enter the SSID.
c. In the Security section, select WEP.
Figure 2-10
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.

NETGEAR RangeMax WNDA3100 Specifications

General

Category	Wireless Adapter
Interface	USB 2.0
Wireless Standards	IEEE 802.11a/b/g/n
Frequency Band	2.4 GHz / 5 GHz
Wireless Data Rates	Up to 300 Mbps
Security	WEP, WPA-PSK, WPA2-PSK
Operating Systems Supported	Windows XP, Windows Vista