NETGEAR RangeMax WNDA3100 User Manual

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
2-6
v1.0, December 2007
1. Use the icon to open the Smart Wizard. The Settings tab displays:
2. Enter the network settings.
a. In the Network Type section, make sure that Access Point (Infrastructure) is selected.
b. In the Profile field, type the name of the profile.
c. In the Network Name (SSID) field, select a network or enter the SSID.
3. Save your settings in a Profile.
a. Click Save Profile.
All the configuration settings are saved in this profile.
b. Click Apply, then click Close to exit, or click Cancel to return to the previous settings.
4. Verify wireless connectivity to your network.
Figure 2-4
Note: You will not get a wireless network connection unless the network SSID
matches exactly the SSID used by the access point.

NETGEAR RangeMax WNDA3100 Specifications

General

Category	Wireless Adapter
Interface	USB 2.0
Wireless Standards	IEEE 802.11a/b/g/n
Frequency Band	2.4 GHz / 5 GHz
Wireless Data Rates	Up to 300 Mbps
Security	WEP, WPA-PSK, WPA2-PSK
Operating Systems Supported	Windows XP, Windows Vista