NETGEAR RAX9 - Set a DHCP Ipv6 Internet Connection

•
Use DHCP Server: Use this method if devices on the LAN cannot receive an IPv6
address through auto configuration but must receive an IPv6 address through a
DHCP server.
•
Auto Config: This is the default setting.
This setting specifies how the router assigns IPv6 addresses to the devices on your
home network (the LAN).
8. In the IPv6 Address/Prefix Length fields, specify the static IPv6 address and prefix
length of the router’s LAN interface.
If you do not specify an ID here, the router generates one automatically from its MAC
address.
9. Select an IPv6 Filtering radio button:
•
Secured: In secured mode, which is the default mode, the router inspects both
TCP and UDP packets.
•
Open: In open mode, the router inspects UDP packets only.
10. Click the Apply button.
Your settings are saved.
Set a DHCP IPv6 Internet connection
To set a DHCP IPv6 Internet connection:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 page displays.
5. From the Internet Connection Type menu, select DHCP.
The page adjusts.
After you click the Apply button, the router automatically detects the information in
the following fields:
User Manual36Specify Your Internet Settings
4-Stream AX1800 WiFi 6 Router Model RAX9 and Model R6600AX