NETGEAR RAX9 - Set a Pppoe Ipv6 Internet Connection

•
Secured: In secured mode, which is the default mode, the router inspects both
TCP and UDP packets.
•
Open: In open mode, the router inspects UDP packets only.
12. Click the Apply button.
Your settings are saved.
Set a PPPoE IPv6 Internet connection
To set a PPPoE IPv6 Internet connection:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 page displays.
5. From the Internet Connection Type menu, select PPPoE.
The page adjusts.
After you click the Apply button, the router automatically detects the information in
the following fields:
•
Router’s IPv6 Address on WAN: This field shows the IPv6 address that is acquired
for the router’s WAN (or Internet) interface. The number after the slash (/) is the
length of the prefix, which is also indicated by the underline (_) under the IPv6
address. If no address is acquired, the field displays Not Available.
•
Router’s IPv6 Address on LAN: This field shows the IPv6 address that is acquired
for the router’s LAN interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
6. Do one of the following:
•
Select the Use the same login information as IPv4 PPPoE check box.
•
Configure the login settings manually:
a. In the Login field, enter the login information for the ISP connection.
User Manual38Specify Your Internet Settings
4-Stream AX1800 WiFi 6 Router Model RAX9 and Model R6600AX