NETGEAR RAX9 - Page 39

This is usually the name that you use in your email address. Some ISPs (like
Mindspring, Earthlink, and T-DSL) require that you use your full email address
when you log in. If your ISP requires your full email address, type it in this field.
b. In the Password field, enter the password for the ISP connection.
c. In the Service Name field, enter a service name.
If your ISP did not provide a service name, leave this field blank.
NOTE: The default setting of the Connection Mode menu is Always
On to provide a steady IPv6 connection. The router never terminates
the connection. If the connection is terminated, for example, when the
modem is turned off, the router attempts to reestablish the connection
immediately after the PPPoE connection becomes available again.
7. Select an IPv6 Domain Name Server (DNS) Address radio button:
•
Get Automatically from ISP: Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns this address. This option uses the DNS servers
assigned by the ISP for the IPv4 connection.
•
Use These DNS Servers: If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP’s primary DNS server. If a secondary
DNS server address is available, enter it also.
8. Select an IP Address Assignment radio button:
•
Use DHCP Server: Use this method if devices on the LAN cannot receive an IPv6
address through auto configuration but must receive the IPv6 address through
a DHCP server.
•
Auto Config: This is the default setting.
This setting specifies how the router assigns IPv6 addresses to the devices on your
home network (the LAN).
9. (Optional) Select the Use This Interface ID check box and specify the interface ID
to be used for the IPv6 address of the router’s LAN interface.
If you do not specify an ID here, the router generates one automatically from its MAC
address.
10. Select an IPv6 Filtering radio button:
•
Secured: In secured mode, which is the default mode, the router inspects both
TCP and UDP packets.
•
Open: In open mode, the router inspects UDP packets only.
11. Click the Apply button.
Your settings are saved.
User Manual39Specify Your Internet Settings
4-Stream AX1800 WiFi 6 Router Model RAX9 and Model R6600AX