NETGEAR ReadyNAS 2120

Table 5. Status indicators
DescriptionIndicator
The Power LED indicates these states:
• Green.The system is powered on.
• Amber.The system is in standby mode.
• Off.The system is powered off.
Power LED (control panel)
The UI LED indicates these states:
• Blue.The system is identified: The UI button was pressed and the UID
LED on the rear panel is lit.
• Off.The system is not identified.
UI LED (control panel)
The Health LED indicates these states:
• Red.The system needs attention. Use the local admin page to determine
the problem. For more information, see the ReadyNAS OS 6.5 Software
Manual, which is available at
http://support.netgear.com/product/ReadyNAS-OS6.
• Off.The system is healthy.
Health LED (control panel)
The LAN LEDs indicate these states:
• Green. An Ethernet cable is connected.
• Blinking.The Ethernet link is active.
• Off.There is no Ethernet connection.
LAN LEDs (control panel)
The top LED indicates disk status, as follows:
• On. A disk is present.
• Off. No disk is present.
The bottom LED indicates disk activity as follows:
• Blinking.The disk is active.
• Off.There is no disk activity.
• Blinking on/off/on/off pattern.The disk failed or is faulty.
Disk LEDs (disk trays)
ReadyNAS 3220 and 4220
46
ReadyNAS OS 6