NETGEAR ReadyNAS 2120

Table 6. Front panel status indicators
DescriptionIndicator
The Power LED indicates these states:
• Solid blue.The system is powered on.
• Off.The system is powered off.
• Blinking blue.The system is entering boot mode.
Power LED
The Health LED indicates these states:
• Solid red.The system needs attention. Use the local admin page to determine the
problem. For more information, see the ReadyNAS OS 6.5 Software Manual, which
is available at support.netgear.com/product/ReadyNAS-OS6.
• Off.The system is healthy.
• Blinking red.The system is entering boot mode.
Health LED
The 10GbE LED indicates these states:
• Green. An Ethernet cable is connected.
• Blinking green.The Ethernet link is active.
• Off.The system did not detect an Ethernet connection.
10GbE LED
The GbE LEDs indicate these states:
• Green. An Ethernet cable is connected.
• Blinking green.The Ethernet link is active.
• Off.The system did not detect an Ethernet connection.
GbE LED
The top LED is the Disk Drive Power LED, which indicates the disk status as follows:
• Blue. A disk is present.
• Off. No disk is present.
The bottom LED is the bicolor Disk Drive Activity and Fault LED, which indicates disk
activity and boot mode as follows:
• Blinking green.The disk is active.
• Off. No disk activity is detected.
• Solid red.The disk failed or is faulty.
• Solid red for all disks.The system entered boot mode.
• Solid red for disks 1 through 7. Indicates the boot mode option. (For infomration
about disk numbering, see Front Panel on page 53.)
Disk LEDs (disk trays)
ReadyNAS 3312 and 4312
57
ReadyNAS OS 6