5. Press and release the Reset button to scroll through the boot menu modes.
The storage system shows the boot mode options using the Power LED, Health LED, and the Disk Drive
Activity and Fault LEDs (A&F LEDs) for disks 1 through 7 (for information about LEDs and disk numbering,
see Front Panel on page 53), as described in the following table:
Status IndicatorsBoot Mode
Disk Drive Activity and Fault LEDsHealth
LED
Power
LED
Description
Disk 7Disk 6Disk 5Disk 4Disk 3Disk 2Disk 1
Power and Health LEDs blink
and all A&F LEDs are solid
red.
Boot menu
A&F LED disk 1 is solid red.Normal
A&F LEDs disks 1 and 2 are
solid red.
Factory
default
A&F LEDs disks 1 through 3
are solid red.
OS reinstall
A&F LEDs disks 1 through 4
are solid red.
Tech
support
A&F LEDs disks 1 through 5
are solid red.
Volume
read only
A&F LEDs disks 1 through 6
are solid red.
Memory
test
A&F LEDs disks 1 through 7
are solid red.
Test disk
Legend:
•
Solid:
•
Blinking:
•
Off:
6. Press and hold the Reset button to confirm your boot menu selection.
The system boots in the selected boot mode.
ReadyNAS 3312 and 4312
61
ReadyNAS OS 6
To Next Page
Loading...
