Hardware Setup
6
802.11ac Wireless Access Point Model WAC120
System Requirements
Before installing the access point, make sure that your system includes the following:
• A 10/100/1000 Mbp
s local area network device such as a hub or switch
• The Category 5 UTP straight-through Ethernet cable with RJ-45 connector included in the
pa
ckage, or one like it
• A 100–120 V, 50–60 Hz AC power source
• A web browser for configuration
• At lea
st one computer with the TCP/IP protocol installed
• 802.11b/g-compliant or 802.11b/g-compliant devices
Unpack Your Access Point
Your package contains the following items.
Access point
Ethernet cable
Power adapter
Figure 1. Package contents
Your box contains the following items:
• 802.11ac Wireless Access Point Model WAC120
• AC power adapter (plug varies by region)
• Category 5 (Cat 5) Ethernet cab
le
• Installation guide with cabling and access point se
tup instructions
If any parts are incorrect, missing, or damaged, contact your NETGEAR dealer.
To Next Page
Loading...
