Wireless-N 300 USB Adapter WNA3100 User Manual
1-11
v1.0, December 2009
3. Select the Remove radio button and then click Next.
4. Follow the onscreen prompt to disconnect your adapter. A message displays confirming that
the software has been removed.
Upgrading the WNA3100 v1 Software
Upgrades might be available at the NETGEAR website. To install an upgrade:
1. Open the Smart Wizard and click the About tab to display the following screen:
2. Click the Software Update Check button.
If a newer version of firmware is found at the NETGEAR website, the following screen
displays:
Figure 1-13
Figure 1-14
To Next Page
Loading...
