NETGEAR WNA3100 - Wireless-N 300 USB Adapter User Manual

Wireless-N 300 USB Adapter WNA3100 User Manual
4-4
v1.0, December 2009
1. Select Start > Control Panel > Add/Remove Programs.
2. Select Windows XP Hotfix (SP2) Q815485, and then click Remove.
• You might receive an error message that states that some programs on the computer might
not work correctly if the update is removed.
• You can ignore this error message, and then click Yes to remove the update.
3. Restart your computer, and rerun the Smart Display Setup Wizard.
This should solve your connection issue. You can restore this hotfix by following this link:
http://microsoft.com/downloads/details.aspx?FamilyId=009D8425-CE2B-47A4-ABEC-
274845DC9E91&displaylang=en.
Ad Hoc Mode Is Not Working Correctly
You must click the Initiate Ad Hoc button on the Settings Tab before you click Apply.
To start an Ad Hoc network:
1. Fill in the Network Name (SSID) field.
2. Select the Computer-to-Computer (Ad Hoc) network type.
3. Click Initiate Ad Hoc.
4. Accept the default settings, or make your changes, and click OK.
5. Click Apply.
Note: Be sure that all computers in your Ad Hoc network are configured with static IP
addresses in the same subnet.

NETGEAR WNA3100 - Wireless-N 300 USB Adapter Specifications

General

Interface	USB 2.0
Frequency Band	2.4 GHz
Data Transfer Rate	Up to 300 Mbps
Security	WEP, WPA, WPA2
Standards	IEEE 802.11b/g/n
Antenna	Internal
Operating Systems Supported	Windows XP, Vista, 7
Wireless Type	802.11b/g/n