NETGEAR WNA3100 - Wireless-N 300 USB Adapter User Manual

Wireless-N 300 USB Adapter WNA3100 User Manual
2-5
v1.0, December 2009
2. Enter the network settings.
a. In the Profile field, type a name for the profile.
b. In the Network Name (SSID) field, select a network, or enter the SSID.
c. In the Network Type section, make sure that Access Point (Infrastructure) is selected.
This setting lets you connect to a wireless network. For help with Ad Hoc mode, see
“Setting Up a Computer-to-Computer (Ad Hoc) Profile” on page 2-6.
3. Click Save Profile.
All the configuration settings are saved in this profile.
4. To use the profile, click Apply.
5. Make sure you can connet to the network.
Use a browser to connect to the Internet, or check for file and printer access on your network.
You can check the status bar in the Smart Wizard for the current connection status. If you
cannot connect, see “Troubleshooting Your Wireless Connection” on page 4-2.
Figure 2-4
Note: You will not get a wireless network connection unless the network SSID
matches exactly the SSID used by the wireless network.

NETGEAR WNA3100 - Wireless-N 300 USB Adapter Specifications

General

Interface	USB 2.0
Frequency Band	2.4 GHz
Data Transfer Rate	Up to 300 Mbps
Security	WEP, WPA, WPA2
Standards	IEEE 802.11b/g/n
Antenna	Internal
Operating Systems Supported	Windows XP, Vista, 7
Wireless Type	802.11b/g/n